Skip to content

Kitchen and Bath Drywall Patch-Ins in Massillon

The plumber is done, the new cabinets are in, and there's a gap in the wall where the old stuff used to be. We close it up so it matches the rest.

Kitchen wall with a freshly taped and coated drywall patch behind where a sink and backsplash will go

The gap nobody else owns

Remodels leave openings. A plumber cuts into a bathroom wall to move a valve. An electrician opens a kitchen wall for a new circuit. Cabinets come out, and the wall behind them has holes, paper missing and a pattern of old adhesive. Everyone moves on to their part, and the wall is left for somebody.

That somebody is us. We close up the walls once the other trades have finished, and we make them look like they were always there.

Massillon kitchens and baths

Many original layouts. The typical Massillon home dates to about 1957, according to census survey data, and roughly three in four structures in the school-district area went up before 1970. Kitchens and baths from that period are often small and tightly built, so updates often open more wall than you'd think.

Owners updating. About 65 percent of homes in Massillon are owner-occupied. Owners tend to update kitchens and baths in stages, which means repeat patching.

Two ZIP codes, one approach. We work across 44646 and 44647. Everywhere in them, the first question is the same: what did the crew do to the wall?

Where patches usually land

Here are the spots we get called to:

  • Behind a relocated sink or tub valve
  • Where wall cabinets came down and left screw holes and torn paper
  • Around a new window, vent fan or recessed light
  • Along a tile line where the old tile took board with it
  • At a new outlet, switch or pot-filler location

How we do the close-up

  1. Wait for the trades. We schedule after the plumber and electrician sign off, so we're not tearing open our own work.
  2. Measure and cut. Fresh board goes in to fit, fastened to studs or backing.
  3. Tape and coat. Seams, corners and edges get thin, sanded coats.
  4. Moisture-minded finishing. In wet areas we leave a surface your tile setter or painter can use, and we tell them what we used.
  5. Blend. We feather out into the surrounding wall.

Remodel patch questions

Do you replace the whole wall?

Rarely. We patch the opening and blend it.

Can you work around tile?

We prepare the surface so tile can be set, but your tile setter does the tile.

What about moisture-resistant board?

In wet areas, we'll use board suited to the spot. Your tile setter can tell us what they prefer.

Should I call you before the contractor leaves?

Yes. A quick chat lets us time it so nobody waits.

A word on timing

Remodel schedules are tight, and drywall sits in the middle of them. The plumber and electrician have to be done and inspected before we close anything up. Tile and paint have to wait for us. So the best thing you can do is give us a rough date early, even before the other crews have finished.

We'd rather chat for five minutes and plan around the tile setter than rush a patch that needs time to dry. Thin coats and patience are what make a seam disappear, and nobody can speed up compound without cost to the finish.

Before we arrive

Help us keep it quick:

  • Make sure the plumber, electrician and cabinet installer are fully done
  • Clear the counters and floor beside the wall
  • Take photos of every opening, with a tape measure in frame if you can
  • Tell us who's doing tile or paint next

Ready when you are

Send us a photo of the kitchen and bath update patch-ins and we'll talk it through.

Got a wall that needs fixing?

Send us a photo and a line or two about what happened. We'll chat about the fix.

CallText us